- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Glossary
Glossary
interface
address
Specify the internet address for the network named in the previ-
ous prompt.
mask bits The subnetwork mask identifies the subnetwork field of a net-
work address. The length of the subnetwork field is chosen by
specifying the number of subnetwork bits that will be used to
formulate the network mask for a subnetted network. Enter
only the number of bits in the host portion of the IP address.
The default number is set to zero. The number of bits specified
represents contiguous bits.
network
name
Specify the name of the network (up to 31 characters) to which
this subnetwork is connected (e.g., dock-net). Network names
may contain letters, numbers, dashes, and underscores.
subnetwork
name
Identifies the subnetwork. Subnetwork names cannot be more
than 31 characters. They may contain letters, numbers, dashes,
and underscores.
Report Fields
The following report fields are found in the LCS60 reports generated by the
status commands (e.g, show, trace, etc.). The report fields are listed according to
the directory in which they are generated.
Session Directory
Show ARAP
Top>Session> show arap
Sesid Session ID number.
Xmit(Bytes) Number of bytes transmitted.
G-8 Issue 3