- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
User Information
SLIP Service Examples
ChameleonNFS 4.0
Note: ChameleonNFS 4.5 is different from ChameleonNFS 4.0. Refer to the
user documentation for specific details.
Before you can make a SLIP connection using ChameleonNFS, you must config-
ure the SLIP interface through Windows; Figures F-10 - F12 show an example
configuration for dynamic IP address acquisition.
1 . Under the Custom window, select Interface and add a SLIP interface.
Figure F-10: Custom Interface Window
2 . Under the Custom Setup window (Figure F-11), configure the following:
• IP address (1.1.1.1 for a dynamic IP address) • Port
• Modem • Dial
• Login (Figure F-12)
User Name field = NAC User ID; User Password field = NAC password; Startup
Command field = SLIP dialstring
Issue 3 F-19