- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
User Information
PPP Service Examples
Notes: US Robotics Sportster in the preceding figure is the dialing script (CCL)
which contains the necessary instructions to set up the modem and log
on to the LCS60. Modem Port selects which device the modem is
connected to; the modem port is usually designated. When setting
your physical link parameters (LCP) you can take the defaults as
shown on the right. Make sure PAP/CHAP authentication are not
selected. Authentication is handled by the NAC.
Figure F-7: IP Address Screen
Note: If you are using a privately administered IP address, enter it in the Local
IP Address field on the screen above, otherwise the LCS60 will
dynamically assign an IP address (when a negotiable IP address has been
administered in the client software package).
Issue 3 F-17