- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
User Information
PPP Service Examples
You can configure the PPP connection options, as described in the PC/TCP
Software documentation by selecting Configure... . You may specify the PPP
LINK and IP negotiation values that will be used during negotiation with the
LCS60 when you make the connection.
The Dialer screen allows you to specify the PPP server to which you would like
to connect and the connection script to use.
Figure F-3: PC/TCP Example Screens
dialup (c:\pctcp\dialmt.scr)
mt60
The choices for servers and scripts are read from the pctcp.ini file. Make sure you
have added a session for the LCS60 server and created the dialup and hangup
scripts for it. Select Configure... to set up your connection configuration for the
LCS60. This will display the screen shown in Figure F-4.
F-12 Issue 3