- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
User Information
Client Software Configuration
@LABEL 21
note "Got Password:"
ask 1 "Enter Password"
write "^*\13"
matchstr 1 22 "DESTINATION:"
jump 59
matchread 400
jump 59
@LABEL 22
write "nj/exch/system.ppp/arap"
note "Sent nj/exch/system.ppp/arap"
Be sure you don’t have conflicts with existing label numbers.
Modem
The great majority of modems will work correctly right out of the box using the
default settings. For the few that do require some configuration:
Make sure the serial speed setting for MSM/TY on the data switch are set
correctly. Check your modem reference for the correct AT commands.
Make sure the MSM/TY data switch modem has answer mode set to pick
up on a certain number of rings (if the number of rings is set to zero, it will
not pick up). Check your modem reference for the correct AT commands.
PPP Service Examples
Windows 95 – IPX over PPP
Note: Windows 95 is equipped with detailed on-line help. For any problems
related to Windows 95, refer to the on-line help or contact Microsoft.
F-6 Issue 3