- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
User Information
Client Software Configuration
USERID, Password,
DESTINATION
Your user ID, password, and DESTINATION.
nj/exch/system.ppp Your LCS60 dialstring for PPP; use the ARAP
dialstring, nj/exch/system.arap, for ARAP.
exit 0 Terminates execution of the script (in this
example, 0 is defined as a good return).
exit -6019 Terminates execution of the script (in this
example, -6019 is defined as a bad return).
@HANGUP Marks the point in the script where execution
begins to hang up.
Note: Refer also to the software documentation.
CCL and Modem Hints
The following are suggestions designed to eliminate problems when setting up
your modem and editing or creating your CCL script. For complete details on
your modem, contact your modem vendor.
CCL
Use a generic CCL script or one specific to your type of modem and add:
@LABEL 19
write "\13"
matchstr 1 20 "USERID"
matchread 400
jump 59
@LABEL 20
note "Got USERID:"
ask 1 "Enter USERID"
write "^*\13"
matchstr 1 21 "Password:"
matchread 400
Issue 3 F-5