- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
User Information
Client Software Configuration
Screen F-1:
Continued
!
@LABEL 59
exit -6019
!
! Attempt to hang up the modem
!
@HANGUP
exit 0
Edit this script with the information appropriate for your modem and
configuration. The entries in the above script are described below:
! Indicates a comment.
@ORIGINATE @ANSWER Labels to begin execution of originate and
answer mode.
xxxxx Anything specific to your modem should go
here. Refer to your modem documentation.
38400 Baud rate.
note “Dialing ˆ 1” Writes to a log.
write “ATDTˆ1” Writes to serial driver.
ask... This line tells the system to prompt for the
information (in this example for the User ID and
password). Without this line, you would need
to hard code the information into the script.
@LABEL 19 Numeric label.
matchstr 1 20... Match incoming characters. The 20 in this line is
a label.
matchread 400 Reads input from the serial driver and compares
the input to the current match string.
F-4 Issue 3