- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
TELNET ( 1 ) TELNET
The valid NVT commands are:
ao send an abort output request
ayt send a message (are you there?) to remote server
brk send a break request
ec send an erase character request
el send an erase line request
dm send a data mark to signify end of urgent data
ip send an interrupt request
nop send a null operation
? display a list of transnvt commands.
z Suspend the telnet session. True job suspension is implemented if sup-
ported by the original shell (csh or ksh). If not (sh), a new local shell will be
created.
NOTES
The TELNET specifications specify defaults for line mode transmission with the
local tty driver echoing. The Wollongong implementation, by default, provides
character mode tranmission with the local tty driver echoing.
DIAGNOSTICS
Exit status is zero for normal termination, a positive number for error termination.
SEE ALSO
telnetd(4)
E-46 Issue 3