- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Features
LAN Protocols
Figure 1-1: LCS60 as an AppleTalk Router
LCS60 (AppleTalk Router)
ARAP
PPP
CommKit Host Interface
ELAP*
Ethernet
* EtherTalk Link Access Protocol. EtherTalk is Apple’s data link protocol that allows
Ethernet cables to be used to connect an AppleTalk network.
AppleTalk Network Number and Zone Assignment
The LCS60 supports dynamic AppleTalk address assignment within a virtual zone
of PPP and ARAP clients. (Refer to Figure 1-2.) Upon dialing into the LCS60, the
PPP client is assigned an available network and node number automatically. The
client then becomes part of the virtual zone configured on the LCS60; no special
dialstring options are used.
Figure 1-2: AppleTalk Virtual Zone
Lucent Data Switch
Network
Mac
Mac
LCS60
1-8 Issue 3