- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
StarKeeper II NMS
Alarms to StarKeeper II NMS
L600640 Process tlid is down.
Description: The tlid process is not executing.
Action: Restart the tlid process by entering lcsadm -c stop tcpip and then lcsadm
-c start all from the LCS60 system console. If the problem occurs again, reboot the
system (cd / ; /etc/shutdown -y -g0 -i6). Refer to the start all command in
Chapter 8.
Call your LCS60 support personnel if the problem persists.
L600645 An IP Network Security Group <servername> process is
down.
Description: An IP Network Security group process is not executing.
Action: Log onto the LCS60 system console and restart the process (or processes)
by executing sh /etc/init.d/ipas_dkitrc restart from the LCS60 system console.
Call your LCS60 support personnel if the problem persists.
L600665 Process atmgr is down.
Description: The atmgr process is not executing.
Action: Restart the atmgr process by entering the lcsadm -c start atalk command
from the LCS60 system console. If the problem occurs again, use the cd /;
/etc/shutdown -y -g0 -i6 command to reboot the system.
Call your LCS60 support personnel if the problem persists.
L600725 Process snmpd is down.
Description: The snmpd process is not executing.
Action: Restart the snmpd process by executing lcsadm -c start snmp from the
LCS60 system console.
Call your LCS60 support personnel if the problem persists.
B-8 Issue 3