- Hewlett-Packard User Guide Printer LCS60

StarKeeper II NMS
Configuration of the StarKeeper II NMS
8 . The next field is optional. At Location enter the location of the LCS60
entered in Step 5 (e.g., room number) followed by a Return or just enter
Return .
9 . At Time zone enter the applicable time zone for the LCS60 entered in Step 5
followed by a Return (refer to the StarKeeper II NMS documentation for
format details).
10 . The next field is optional. At Comment enter a comment (or nothing) and
press Ctrl-g .
11 . At Console press Return .
12 . At Alarms enter y Ctrl-t to indicate that the LCS60 uses an Alarms-type
connection.
13 . At Status enter a followed by Return if you are ready for StarKeeper
II NMS to begin monitoring this LCS60.
If you are not ready for StarKeeper II NMS to begin monitoring this
LCS60 (for example, you are populating the database in anticipation of
deploying an LCS60), enter i Return .
14 . At Method enter h followed by Return to indicate that StarKeeper II
NMS should use its host fiber interface to monitor the LCS60.
15 . At Dial string enter the area/exchange/name of the LCS60 entered in Step 5
followed by a carriage return (e.g., mlkway/earth/morse Return ), that
is, the data switch call address that StarKeeper II NMS should use to mon-
itor the LCS60.
16 . At Password enter Return to use the default password.
17 . At Host Number select the StarKeeper II NMS host interface number that
should be used to monitor the LCS60. Enter 0 Return .
18 . At StarKeeper II NMS name field, if the field is not already populated, enter
the name of the StarKeeper II NMS that will monitor this LCS60 and then
enter Ctrl-g .
The StarKeeper II NMS should confirm the entry of the LCS60 with Alarms
connection has been added.
19 . Press Delete (6386) or Break (HP) three times to exit the menu sys-
tem. At the CONFIRM EXIT prompt, enter Return to return to the main
selection menu.
Issue 3 B-5