- Hewlett-Packard User Guide Printer LCS60

Table Of Contents

StarKeeper II NMS

Configuration of the StarKeeper II NMS

# cd /tmp

# mt rew

# cpio -ivdumB < /dev/rmt/0mn

# ./UNINSTALL

c . Enter i Return when you see the following:

Connections for L60 must either be removed or made inactive.

If you are upgrading L60 you should make the connections inactive,

otherwise connection information will have to be re-entered.

Enter "r" to remove, or "i" to make inactive: i

d . Remove the diskette or tape from the drive.

5 . Enter the package installation command and follow the instructions:

For 6386

Hardware

Enter /usr/bin/installpkg; then enter F to install the

floppy diskette. Insert the floppy diskette labeled LCS60

Network Interface for Ethernet R3.0 StarKeeper® NMS RX.Y

Support for AT&T 6386 into the disk drive when instructed

to do so.

For HP

Hardware

Insert the tape labeled LCS60 Network Interface for Ethernet

R3.0 StarKeeper® NMS RX.Y Support for Hewlett-Packard

into the tape drive and wait until the light stops blinking.

Then execute the following four commands:

# cd /tmp

# mt rew

# cpio -ivdumB < /dev/rmt/0mn

# ./INSTALL

Issue 3 B-3