- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
VMEDKHS Diagnostics
This task must be performed within 60 seconds!
Type yes To Continue, no To Stop Command:
CONTINUE TESTING [ yes, no: +(yes) ]: yes
90-08-18 13:47:57 NODE=NODENAME
M diagnose cpm 11 local_loop
DIAGNOSTIC EXITS
CC0> diag cpm 11
TEST TYPE [command_logic, module_reset,
local_loop, remote_loop]: remote_loop
Ask the host computer administrator to replace the fiber
optic link connection on the FIB paddle board with a loop-around connector.
This task must be performed within 60 seconds!
Type yes To Continue, no To Stop Command:
CONTINUE TESTING [ yes, no: +(yes) ]: yes
90-08-18 13:48:10 NODE=NODENAME
M diagnose cpm 11 remote_loop
DIAGNOSTIC EXITS
CC0> res cpm 11
CC0> display conn mod 11
Note: A message stating "UNIX Server Dead" may appear; ignore this message
and continue.
Restore the CPM-HS to service as shown in Screen 9-7 (res cpm #).
Verify that the CPM-HS is active as shown in Screen 9-7 (display
conn mod #).
4 . Restart the LCS60 software using the start dkhost command from the
lcsadm interface.
Issue 3 9-27