- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Processor Diagnostics - MVME197
The MVME197 automatically runs its processor diagnostics on start up, after
power is applied, and after a reset has occurred. If an error is found, it will be
displayed on the console, if possible, and the FAIL LED will be turned on (refer
to Figure 9-1).
Figure 9-1: Faceplates
MVME
197LE
FAIL
SCON
RUN
LAN
VME
SCSI
TX
RX
ABORT
RESET
To run additional diagnostics on the MVME197 processor board, conduct the
following dialogue to obtain the diagnostics prompt and list the available
diagnostics:
Note: For complete details of available diagnostics and how to run them, refer
to the Motorola document, MVME197 Single Board Computer Diagnostics
Firmware User’s Manual.
197-Bug> sd
197-Diag> he
AEM Append Error Messages Mode
BSW BusSwitch Tests (DIR)
CEM Clear Error Messages
CF Configuration Editor
DCAM DCAM Tests (DIR)
DE Display Errors
DEM Display Error Messages
Issue 3 9-23