- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Processor Board Firmware Update
Screen 9-6: set and env Commands
Copyright Motorola Inc. 1988 - 1994 All Rights Reserved
MVME197 Debugger/Diagnostics Release Version 1.1 - 06/17/94 (06_17.94)
Local Memory Found = 02000000 (&33554432)
MPU Clock Speed =50Mhz
Initializing Local Memory... 02000000 Done
Idle MPU(s) : NONE
•
•
•
197-Bug> set 0310951210
197-Bug> env
Bug or System Environment [B/S]= B? b
Field Service Menu Enabled [Y/N]= N? n
Remote Start Method Switch [G/M/B/N]= B? b
Probe System for Supported I/O Controllers [Y/N]= Y? y
Negate VMEbus SYSFAIL* Always [Y/N]= N? n
Local SCSI Bus Reset on Debugger Startup [Y/N]= Y? y
Local SCSI Bus Negotiation Type [A/S/N]= A? a
Ignore CFGA Block on a Hard Disk Boot [Y/N]=Y?Y
Auto Boot Enable [Y/N]= N? Y
Auto Boot at power-up only [Y/N]= Y? N
Auto Boot Controller LUN = 00?.
Update Non-Volatile RAM [Y/N]? y
Reset Local System CPU? y
3 . Once you have completed the dialogue shown in Screen 9-6, the system
will perform an autoboot.
9-22 Issue 3