- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Processor Board Firmware Update
_ ____________________________________________
Master Enable #2 [Y/N]=N? N
_ ____________________________________________
Master Starting Address #2 = 00000000? 0
_ ____________________________________________
Master Ending Address #2 = 00000000? 0
_ ____________________________________________
Master Control #2 = 00? 0
_ ____________________________________________
Master Enable #3 [Y/N]=N? N
_ ____________________________________________
Master Starting Address #3 = 00000000? 0
_ ____________________________________________
Master Ending Address #3 = 00000000? 0
_ ____________________________________________
Master Control #3 = 00? 00
_ ____________________________________________
Master Enable #4 [Y/N]=N? N
_ ____________________________________________
Master Starting Address #4 = 00000000? 0
_ ____________________________________________
Master Ending Address #4 = 00000000? 0
_ ____________________________________________
Master Address Translation Address #4 = 00000000? 0
_ ____________________________________________
Master Address Translation Select #4 = 00000000? 0
_ ____________________________________________
Master Control #4 = 00? 0
_ ____________________________________________
Short I/O (VMEbus A16) Enable [Y/N]=Y? Y
_ ____________________________________________
Short I/O (VMEbus A16) Control =01? 01
_ ____________________________________________
F-Page (VMEbus A24) Enable [Y/N]=Y? Y
_ ____________________________________________
F-Page (VMEbus A24) Control =02? 02
_ ____________________________________________
ROM Speed Bank A Code = 02? 02
_ ____________________________________________
ROM Speed Bank B Code = 02? 02
_ ____________________________________________
PCC2 Vector Base = 05? 05
_ ____________________________________________
VMEC2 Vector Base #1 = 06? 06
_ ____________________________________________
VMEC2 Vector Base #2 = 07? 07
_ ____________________________________________
VMEC2 GCSR Group Base Address = D0? D0
_ ____________________________________________
VMEC2 GCSR Board Base Address = 00? 00
_ ____________________________________________
VMEbus Global Time Out Code =01? 01
_ ____________________________________________
Local Bus Time Out Code =01? 01
_ ____________________________________________
VMEbus Access Time Out Code =02? 02
_ ____________________________________________
Update Non-Volatile RAM [Y/N]?
1
Y
_ ____________________________________________
Reset Local System (CPU) [Y/N]?
1
Y
_ ____________________________________________
_ ____________________________________________
1 These prompts update the parameter values you enter and reboot the machine.
Issue 3 9-21