- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Reload System Software
the LCS60 and the individual protocols and/or services you want to be up
whenever the system is rebooted.
Before you run "lcsadm" you should read about LCS60 configuration in the "LCS60
Network Interface Installation and Administration Guide" and assemble the
information required for configuration.
The system is ready.
morse
Console Login:
After the screen above is displayed, complete the installation by:
1 . Logging on as root
Note: As shipped, the root password is the Return key. Change the
root password as soon as you log on.
2 . Accessing the lcsadm Interface
3 . Running initsetup and srvsetup (as required) as described in Chapter 3.
Removing the LCS60 Application Software
Before removing the LCS60 application software stop the configured protocols
and services by entering lcsadm -c stop all from the root prompt. Remove the
LCS60 application software by conducting the dialogue (as root; from the Con-
sole login) shown in Screen 9-5.
Issue 3 9-13