- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Reload System Software
Multiprocessor Kernel Debugger Release 4 Version 4
Copyright (c) 1988 UNISYS.
Copyright (c) 1991, 1992, 1993 Motorola, Inc.
All rights reserved.
Found 1 CPU(s)
NOTICE: MP Locking disabled
STREAMS threshold = 13738550
Max STREAMS memory = 26103245
UNIX(R) MP System V Release 4.0 Motorola m88k Version R40V4.2
Total real memory = 33554432
Available memory = 27648000
Copyright (c) 1984, 1986, 1987, 1988, 1990 AT&T
Copyright (c) 1991 UNIX System Laboratories, Inc.
Copyright (c) 1987, 1988 Microsoft Corp.
Copyright (c) 1990, 1991, 1992, 1993 Addamax
Copyright (c) 1990, 1991, 1992, 1993 Motorola, Inc.
All Rights Reserved
Node: morse
Enter <CR> to pause in a single user shell before init.
Default boot sequence continuing...
Updating modules with master file contents
/stand/unix is being created.
found in in-core EDT: BSW id 0
found in in-core EDT: CONS1X7 id 0
•
•
•
Node: morse
Enter <CR> to pause in a single user shell before init.
Default boot sequence continuing...
The system is coming up. Please wait.
configuration change detected: creating device nodes
sadc: Building symbols in /tmp/sa.adrfl for /stand/unix
Starting process accounting
Print services started.
Welcome!
Your LCS60 Network Interface must be set up by you. When you see the "login"
prompt you must login as "root" and then type:
lcsadm config initsetup
followed by the RETURN key. This will lead you through the steps to configure
9-12 Issue 3