- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Reload System Software
inet Package Removal
The LCS60 Application tape will initialize its own version of the inet package,
therefore it is essential that you remove the existing inet package. Remove the
inet package by conducting the dialogue shown Screen 9-3.
Screen 9-3: inet Package Removal
# pkgrm inet
The following package is currently installed:
inet Internet Utilities
(m88k) FH40.42 IR03.111393
Do you want to remove this package [y,n,?,q] y
## Removing installed package instance <inet>
## Verifying package dependencies.
WARNING:
The <Motif> package depends on the package currently
being removed.
WARNING:
The <compat> package depends on the package currently
being removed.
WARNING:
The <nfs> package depends on the package currently
being removed.
Dependency checking failed.
Do you want to continue with the removal of this package [y,n,?,q] y
## Processing package information.
## Executing preremove script.
•
•
•
## Updating system information.
Removal of <inet> was successful.
9-8 Issue 3