- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Maintenance
Reload System Software
1) Automatic 1-disk installation
2) All automatic disk configuration options
3) Manual disk configuration
4) Read the disk configuration from the disk(s)
Enter option number of choice: [ 1-4 ] ( 1 ) Return
Final Verification of 1-disk installation BOOT COMMAND: "bo 0 0"
Device Disk description Format? Space Left
m197_c0d0 1GB SCSI (SEAGATE) No 1073402
Partition Slice Size FS Block Size
/ m197_c0d0s0 58000 ufs 4K
swap m197_c0d0s1 300000 - -
/stand m197_c0d0s2 25000 bfs -
/usr m197_c0d0s3 360000 ufs 4K
/var m197_c0d0s4 120000 ufs 4K
/home m197_c0d0s5 100000 ufs 4K
/tftpboot m197_c0d0s6 22000 s5 2K
1) Proceed with installation using configuration shown
2) Change file system type and return to this screen
3) Change disk formatting and return to this screen
4) Change slice size and return to this screen
Enter option number of choice: [ 1-4 ] ( 1 ) 3
Final Verification of 1-disk installation BOOT COMMAND: "bo 0 0"
Device Disk description Format? Space Left
m197_c0d0 1GB SCSI (SEAGATE) Yes 1073402
Partition Slice Size FS Block Size
/ m197_c0d0s0 58000 ufs 4K
swap m197_c0d0s1 300000 - -
/stand m197_c0d0s2 25000 bfs -
/usr m197_c0d0s3 360000 ufs 4K
/var m197_c0d0s4 120000 ufs 4K
/home m197_c0d0s5 100000 ufs 4K
/tftpboot m197_c0d0s6 22000 s5 2K
1) Proceed with installation using configuration shown
2) Change file system type and return to this screen
3) Change disk formatting and return to this screen
4) Change slice size and return to this screen
Enter option number of choice: [ 1-4 ] ( 1 ) 1
8 . The system will ask if you want to install Motif, NCD, and X11 package
features. (Examples are shown below.) Choose the defaults by entering
Return .
9-4 Issue 3