- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Administration
Status
LCS60 STATUS REPORT
====================
Ethernet interface status:
Interface to en0 is UP.
Data Switch status:
Fiber Interface to data switch is UP.
Process status:
ipxd is UP.
sapd is UP.
routed is UP.
snmpd is UP.
tlid is UP.
inetinit is UP.
lcm is UP.
dkdaemon is UP.
morse is UP (IP Network Security Group).
Techs is UP (IP Network Security Group).
Library is UP (IP Network Security Group).
atmgr is UP.
Note: If dkdaemon is DOWN, you must stop dkhost and then start dkhost.
Error Messages
Note: For alarms to StarKeeper II NMS, refer to Appendix B.
Error messages are displayed on the LCS60 system console.
Issue 3 8-41