- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Administration
Logging On
System Console
Log on at the system console and enter lcsadm at the root prompt to obtain access
to all LCS60 administrative operations.
Remote Administration
The LCS60 is provided with a remote access feature which is delivered in the dis-
abled state. The system administrator can enable this feature:
1 . Go to the srvtab directory:
# cd /etc/opt/dk/srvtab
2 . Edit the file lcsadm
3 . Delete the # sign from the line:
#* lcsadm t bin /bin/lcsadm lcsadm:-r:%p
Once enabled, system administration can be performed by accessing the lcsadm
Interface from a remote terminal. To log on remotely, use one of the strings
shown below for the LCS60 morse.
DESTINATION: mlkway/earth/morse.lcsadm
Circuit Open
LCS60 Administrative Command Interface. Enter ’RETURN’ key for command list!
morse:Top>
8-2 Issue 3