- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Gateway
LCS60 Configuration and Connection for Gateway Service
Note: The user should familiarize him/herself with all aspects of the LCS60
gateway service. For details, including a description of service ports,
refer to Chapter 1.
After configuring the LCS60 as described under Initial Setup in Chapter 3, per-
form the steps shown in Figure 7-2 to configure the LCS60 Gateway Services.
Figure 7-2: Gateway Services Configuration
maxsessions
srvports
start all
telnet
socket
directory
config protocol
tcpip
tcpasy
asytcp
etherif
srvsetup
1 . Enter the lcsadm interface.
2 . Add the gateway service:
From the Config directory, enter protocol, or enter config protocol
at the Top directory.
Add tcpip (as required).
Add tcpasy and/or asytcp as required.
3 . Define the Gateway service sessions (maxsessions):
7-2 Issue 3