- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
Gateway
LCS60 Configuration and Connection for
Gateway Service
Figure 7-1 shows an example network using gateway services.
Figure 7-1: Example Network – Gateway Services
Lucent Data Switch
Asynchronous Host
NAC
LCS60
LCS60
LCS200
Modem Pool
Remote
Access
Clients
You can configure the LCS60 for gateway services using either the srvsetup
command or the individual commands (protocol, maxsessions, etherif). The
examples in this chapter use the individual commands.
If previous configuration (for example, for TCP/IP service) has been done, some
of the steps required for configuring LCS60 for gateway services may have
already been completed (e.g., protocol, etherif). Skip the steps that have been
completed previously.
Issue 3 7-1