- Hewlett-Packard User Guide Printer LCS60

ARAP
Administration
Log File
The log file, arap.log is written to by the LCS60 interface software and contains
information about incoming ARAP call requests. To display the contents of the
arap.log file, use the page command as shown in the example below:
# pg /usr/adm/lcs/arap.log
Fri Jun 2 15:41:04 23961 [3] arap1 started loglevel = 3
Fri Jun 2 15:41:04 23961 [3] arap1 nfiles=256
Tue Jun 20 13:15:55 2159 [3] ARAPTOSS dk=mlkway/earth/topper.36.20 uid=5126 \
arap is temporarily disabled
Tue Jun 20 13:16:19 2188 [3] arap1 started loglevel = 3
Tue Jun 20 13:16:20 2188 [3] arap1 nfiles=256
Tue Jun 20 13:16:29 2188 [3] arap1 NEW 1.1 dk=mlkway/earth/topper.36.20 ch=510 \
uid=5126
Tue Jun 20 13:17:30 2188 [3] arap1 1.1 Connect Failed, r=4
Tue Jun 20 13:17:30 2188 [3] arap1 DEL 1.1
Wed Jun 21 08:15:01 2188 [3] arap1 exited
•
•
Related Commands
The following commands may be of particular interest when administering the
LCS60’s ARAP service:
• atping • atnetstat • atlog
The manual pages for these commands are contained in Appendix E of this docu-
ment; they are also available online.
Issue 3 6-7