- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
ARAP
LCS60 Configuration and Connection for ARAP Service
ARAP Service Connection Dialstring
The following type of dialstring (shown with the area/exch/name from the exam-
ple in Figure 6-1) is used to make the ARAP connection.
DESTINATION: mlkway/earth/brown.arap
Administration
Routine administration of the LCS60 includes ARAP tasks such as starting and
stopping ARAP and generating ARAP-specific reports. This section gives some
examples of ARAP-specific tasks. Refer to Chapter 8 for complete LCS60
administration and to the Glossary for a description of the report fields gen-
erated by the administrative commands.
Show Service Example
The following screen illustrates a check of the current status of arap service.
Top>Service># show arap
LCS60 AppleTalk Remote Access Service Statistics: Jan 31 10:45:32
Cfg. Use Cap. Max. Total Busy Fail State
==== === ==== ==== ====== ==== ==== =====
50 4 8% 4 32 0 0 Enabled
Issue 3 6-5