- Hewlett-Packard User Guide Printer LCS60

ARAP
LCS60 Configuration and Connection for ARAP Service
Screen 6-1: Continued
VIRTUAL NETWORK ZONE NAME .. <Research Lab>
NOTE: Changes to the configuration of the LCS60 virtual AppleTalk network
will not take effect until you:
- Enter the lcsadm command and then type ’start atalk’ from the top command
directory to start AppleTalk protocol.
CONFIGURE ADDRESS AND ZONE FOR APPLETALK VIRTUAL NETWORK
1 Configure Address and Zone Name
2 Display Address and Zone Name
3 Delete Address and Zone Name
Enter Menu Selection
[ Type q to quit or ? for help ]
==> q
Top>Config>#
The virtual AppleTalk network address and the zone name must be
defined; they are used for the dynamic allocation of AppleTalk addresses
for PPP and ARAP sessions.
Note: Do not use the AppleTalk address shown in the example; follow your
corporate AppleTalk address convention.
6 . From the Top directory, enter start all.
7 . To complete ARAP configuration, you must configure the client side of
the service. Refer to the documentation included with your client
software; examples of some software packages are given in Appendix F.
To unconfigure ARAP service: stop the service using stop arap, enter
maxsessions at the Top>Config># prompt, and choose option 2 to delete the
service.
6-4 Issue 3