- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
ARAP
LCS60 Configuration and Connection for ARAP Service
Figure 6-2: Configuring ARAP Service
maxsessions
config protocol
atalk arap
configure client
side of ARAP
service
atalkas
obtain virtual
Datakit VCS
network name
start all
etherif*
srvsetup
* etherif is not required for
ARAP service, however, it
is required if other services
(such as PPP) are being
configured as well
1 . Obtain the AppleTalk network number and zone name for the virtual
network. The network number must be unique in the AppleTalk internet.
2 . Enter the lcsadm interface.
3 . Add the ARAP service:
Enter protocol from Config, or config protocol from the Top
directory.
Add atalk (as required).
Add arap.
4 . Define the ARAP service sessions (maxsessions):
Enter max from Config, or config maxsessions from the Top
directory.
Assign the number of ARAP sessions. (The total number of
sessions is 120 when ARAP is configured.)
6-2 Issue 3