- Hewlett-Packard User Guide Printer LCS60

SLIP
LCS60 Configuration and Connection for SLIP Service
Note: Do not use the IP addresses shown in the example as they should follow
your corporate IP address convention.
7 . Configure the Ethernet interface (etherif):
Enter etherif at the Top>Config># prompt or enter config etherif
from the Top directory.
Follow the on-screen instructions for configuring the ethernet
interface. (Refer to the example in Screen 5-3.)
Screen 5-3: Configure the Ethernet Interface – Example
Top>Config># etherif
TCP/IP ETHERNET INTERFACE CONFIGURATION MENU
1 Configure an Ethernet Interface
2 Delete an Ethernet Interface
3 Display all Interfaces that are configured
Enter Menu Selection
[ ? for help, q to quit, RETURN for menu ]
==> 1
WARNING !!
This option will automatically delete each interface that was
previously configured. It reconstructs the Ethernet interface
database from scratch and requires the user to reconfigure
each interface again.
Enter a name for Ethernet Interface 0
[? for help, q for menu]
==> morse-e0
Enter aliases for morse-e0
Separate each alias with blanks
Hit return if there are no aliases [q to quit]
==> mor
Enter morse-e0 internet address (e.g. 154.11.21.1) [q to quit]
==> 154.12.21.5
Enter official name of network [154.12] or q to quit
==> dock-net
Screen 5-3: continued on next page
Issue 3 5-7