- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
PPP
LCS60 Configuration and Connection for PPP Service
1 . Have administered a negotiable IP address in your client software pack-
age
2 . Enter this address (e.g., 0.0.0.0 in some packages) on the appropriate
screen as documented for your client package
3 . Append the -D option to the data switch dialstring:
DESTINATION:
area/exch/60name.ppp..-D
For example:
DESTINATION: mlkway/earth/morse.ppp..-D
Administration
Routine administration of the LCS60 includes PPP tasks such as starting or stop-
ping PPP and generating PPP-specific reports. Refer to Chapter 8 for complete
LCS60 administration and the Glossary for a description of the report fields gen-
erated by the administrative commands.
Show Session Examples
The following screen shows how to check:
4-18 Issue 3