- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
PPP
LCS60 Configuration and Connection for PPP
Service
Figure 4-1 shows an example network using PPP service.
Note: PPP service using AppleTalk requires an R2.0 or R3.0 software key. IPX
service requires an R3.0 software key. Refer to Chapter 3 for information
about the software key.
Figure 4-1: Example Network – PPP Service
Lucent Data Switch
Mac
Modem Pool
LCS60
LAN
Mac
Novell File Server
Apple Printer
Workstation
Remote Access Clients
You can configure the LCS60 for PPP service using either the srvsetup command
or the individual commands (protocol, maxsessions, ipas, ipx, atalkas, etherif).
The examples in this chapter use the individual commands.
If previous configuration (for example, for SLIP service) was performed, some of
the steps required for configuring the LCS60 for PPP service may have already
been completed (e.g., etherif, ipas). Skip the steps that have been completed pre-
viously.
Issue 3 4-1