- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
LCS60 Software
Configuration Changes
Note 2: The addhost and viewhosts commands display only the hosts
configured in the local system database. If DNS is used on your
system the nslookup command can be used to display host
information.
Administrative and Maintenance Commands
In addition to the commands described in the previous sections, the following
administrative/maintenance commands are also available from the Config direc-
tory. Refer to the chapter listed in Table 3-3 for details of these commands.
Table 3-3: Administrative/Maintenance Commands – Config Directory
_ ____________________________________________________
Operation Command Description
_ ____________________________________________________
Enable/disable autobaud console see Chapter 8
Backup/restore functions backup see Chapter 8
Remote upgrade upgrade see Chapter 9
_ ____________________________________________________
_ ____________________________________________________
Issue 3 3-29