- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
LCS60 Software
Configure Default Route, DNS, and SNMP
[? for help, q to quit]
==> q
Top>Config>#
Be sure to specify routed with the protocol command to start DNS service at
boot time.
SNMP Manager – snmp
Use the snmp command to define the SNMP manager as shown in the example
below.
Top>Config># snmp
SIMPLE NETWORK MANAGEMENT PROTOCOL (SNMP) CONFIGURATION
1 Display Current Configuration File
2 Modify/Create Configuration File
Enter Menu Selection
[? for help, q to quit, RETURN for menu]
==> 2
Enter Network Administrator’s Information [?, q]
==> my name
Enter Machine Location [?, q]
==> my location
Enter Community Name [?, d, q]
==> public
IP address of SNMP manager for community "public" [?, q]
==> 0.0.0.0
Access right for SNMP manager "0.0.0.0" [r, w, ?, q]
==> r
Adding the following information to the configuration file:
community public 0.0.0.0 read-only
Confirm? [y, n] y
Enter Community Name [?, d, q]
==> traps
3-26 Issue 3