- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
LCS60 Software
Configure Default Route, DNS, and SNMP
Domain Name Server – dns
Use dns to define the Domain Name Server as shown in the example below.
Top>Config># dns
DOMAIN NAME SYSTEM (DNS) CONFIGURATION
1 Display Current Configuration
2 Modify/Create DNS Resolver Configuration
3 Enable/Disable DNS
Enter Menu Selection
[? for help, q to quit]
==> 2
Enter Domain Information [?, q]
==> ny.att.com
Enter Name Server [?, q]
==> 154.12.21.110
Enter Name Server [?, q]
==> 154.12.48.5
Enter Name Server [?, q]
==> q
DOMAIN NAME SYSTEM (DNS) CONFIGURATION
1 Display Current Configuration
2 Modify/Create DNS Resolver Configuration
3 Enable/Disable DNS
Enter Menu Selection
[? for help, q to quit, RETURN for menu]
==> 3
This system is configured with DNS DISABLED.
Enable DNS? [y, n] y
Your change "will only" become effective when you exit (i.e., quit)
from this menu.
Warning to administrator:
-------------------------
To ensure your subsequent TCP/IP commands will use DNS,
YOU SHOULD LOGOFF THEN RE-LOGIN AFTER EXITING lcsadm
Type RETURN to continue: Return
DOMAIN NAME SYSTEM (DNS) CONFIGURATION
1 Display Current Configuration
2 Modify/Create DNS Resolver Configuration
3 Enable/Disable DNS
Enter Menu Selection
Issue 3 3-25