- Hewlett-Packard User Guide Printer LCS60

LCS60 Software
Configure Default Route, DNS, and SNMP
Default Route – dftroute*
Use the dftroute command to define the default route as shown in the example
below.
The default route may be entered either as a host name or as a TCP/IP dotted
numerical address (e.g., holmes or 154.12.21.3). The host name entered as the
default router must exist in the LCS60 configuration database; use the addhost
command to add the host as necessary.
Top>Config># dftroute
CURRENT default route is . . . . . . . None
DEFAULT ROUTE FUNCTIONS
====================================================
1 ... Define the default route
2 ... Delete the default route
To select a function, enter the corresponding number
[ Type q to quit or ? for help]
==> 1
CAUTION: The default route defined here will be overridden if a
router is advertising a default route in the network.
Enter default router (name, alias, or internet address)
[ Type q to quit or ? for help ]
==> 154.12.21.3
Trying to reach host "154.12.21.3" ... OK.
CURRENT default route is ....... None
NEW default route will be .. 154.12.21.3
Enter y to confirm NEW default route "154.12.21.3"
Enter n to reject NEW default route "154.12.21.3"
==> y
Top>Config> #
Be sure to specify routed with the protocol command to start default route ser-
vice at boot time.
* The dftroute command cannot be run unless the TCP/IP protocol is running.
3-24 Issue 3