- Hewlett-Packard User Guide Printer LCS60
Table Of Contents
- TR.PDF
- 1.PDF
- 2.PDF
- Hardware Installation
- Introduction
- Site Preparation
- Assembly
- Installing the LCS60
- Rack Mounting
- Wall Mounting
- Table-Top Mounting
- Connecting the System Console
- Direct Connection to the LCS60
- Connection through a Data Switch
- Connection through Modems
- Connection through StarKeeper II NMS
- Connecting the Fiber Interface
- Configuration of the Lucent Technologies Data Switch ± LCS60
- Power and Grounding
- Verify LCS60 Console Connection
- Verify Fiber Connection
- Configure the LCS60
- LAN Connections
- Hardware Installation
- 3.PDF
- 4.PDF
- 5.PDF
- 6.PDF
- 7.PDF
- 8.PDF
- Administration
- Basics
- Logging On
- lcsadm Interface
- Typical Administrative Tasks
- Backup and Restore Operations
- Network Access Password Option
- Status
- Error Messages
- Administration
- 9.PDF
- 10.PDF
- 11.PDF
- 12.PDF
- 13.PDF
- 14.PDF
- 15.PDF
- 16.PDF
- IX.PDF
LCS60 Software
Configure Protocols and Gateway Services — srvsetup
==> 3
The LCS60 IPX Parameters are configured as follows:
Ethernet Network Number ..... < 1562 >
Virtual Network Number ...... < 57 >
Ethernet Frame Type ......... < Ethernet II >
CAUTION: Please refer to the I&A Guide for instructions
about configuring this feature.
IPX CONFIGURATION MANAGEMENT
1 Ethernet interface configuration parameters
2 Virtual (PPP) interface configuration parameters
3 Display all Parameters
Enter Menu Selection
[ ? for help, q to quit, RETURN for menu ]
==> q
This completes your configuration of protocols and services on this LCS60.
To start ALL configured protocols and services, enter the command "lcsadm" and
then from the top command directory type "start all".
Top>Config>#
Configure Default Route, DNS, and SNMP
The following optional commands allow you to:
Define a default route
Define the Domain Name Server
Define an SNMP manager.
Issue 3 3-23