Reference Guide

To install the HP postscript level 3 emulation printer driver, navigate to the appropriate folder and

select the appropriate file:

●

For 32-bit: \Drivers\win2k_xp_vista\hppcps08.inf

●

For 64-bit: \Drivers\winxp_vistax64\hppdps08.inf

8. Click Open.

9. On the Install from Disk dialog box, click OK.

10. Click Next. Complete the installation. When prompted, print a test page to ensure that the printer

driver is installed correctly.

General Windows installation for network connections

●

Network setup

●

Windows installation instructions for network-connected products

●

Printer-driver only installation instructions (Microsoft Add Printer Wizard)

Network setup

NOTE: Set up, turn on, and connect the product to the network before installing the software.

To connect a product to a network, use the following instructions:

1. Connect the product to the network.

2. Turn on the product.

NOTE: You must complete the power-up sequence in this order or the installer discovery utility

fails to recognize the product. It might take a few minutes for the product to obtain a TCP/IP

address.

3. To print a configuration page from the product control panel, touch Setup . Use the arrow

buttons to select Reports, and then touch OK. Use the arrow buttons to select Config Report

and then touch OK.

4. Install the printing-system software. Use the information from the test pages to specify the network

variables during installation.

NOTE: A second page prints. On that page, the Fax Settings and Imaging Settings sections

provide details about the product fax settings.

Windows installation instructions for network-connected products

NOTE: Complete the network setup before completing this procedure.

Each computer that has the printing-system software installed can use all of the product features that are

available over a network connection, except for the Receive faxes to this computer feature,

which can only be enabled for one computer.

ENWW

General Windows installation instructions