Reference Guide

Table 6-4 Fax receive error codes (continued)
Error code Description Solution
281 The receiving product has not received any data at
the start of a page during non-ECM reception,
although the modem has not detected a sending
disconnect. The sending product is probably
transmitting fill bytes instead of data and has either
jammed or broken.
Reattempt the fax reception after first requesting
that the sender check the sending product.
282 The receiving product has not received any data at
the start of a page during ECM reception although
the modem has not detected a sending disconnect.
The sending product is probably transmitting sync
frames instead of data and has either jammed or
broken.
283 The receiving product has detected that the modem
carrier has stopped. Either the line has been
disconnected or the sending product has aborted
the transmission.
284 The receiving product has not received any data
during non-ECM page reception and a timeout
failure has occurred. The sending product is
probably transmitting fill bytes instead of data and
has either jammed or broken.
285 The receiving product has stopped receiving any
data during an ECM page reception although the
modem has not detected a sending disconnect. The
sending product is probably transmitting sync
frames instead of data and has either jammed or
broken.
286 The sending product has transmitted invalid data.
The receiving product has received frames with
errors during an ECM reception and requested
retransmission of the errored frames. The data that
is resent does not correspond to the data that was
requested. This is an implementation error from the
sending product.
Disable ECM and reattempt the reception.
290 The sending product has attempted to renegotiate
the session mode from ECM to non-ECM between
pages. This operation is not supported and the
session has been abandoned.
Reattempt the fax reception and split the document
into two portions corresponding to the ECM and
non-ECM portions. Some products will attempt to
use non-ECM for photo mode, so this may be
associated with a between-page encoding change
to support photo mode.
ENWW
Solve fax problems
209