Reference Guide

Recommended action
Touch the OK button to cancel the job.
Break the job into smaller jobs that contain fewer pages.
Turn the product off and then on to clear the memory.
Memory low Only 1 copy made. Press OK to continue.
Description
The product does not have enough memory to complete the collated copy job.
Recommended action
Break the job into smaller jobs that contain fewer pages.
Turn the product off and then on to clear the memory.
Misprint, Press OK
Description
Feed delay misprint.
Recommended action
Verify that paper is loaded in the input tray.
Reload paper.
No dial tone.
Description
The product could not detect a dial tone.
Recommended action
Check for a dial tone on the phone line by touching the Start Fax button.
Unplug the telephone cord from both the product and the wall and replug the cord.
Make sure that you are using the telephone cord that came with the product.
Open the Service menu, and touch the Fax Service button. Touch the Run Fax Test button. This test
verifies that the phone cord is connected to the correct port and that the phone line has a signal. The
product prints a report with the results.
ENWW
Tools for troubleshooting
163