User Guide

Device separation pad
NOTE Some photos show a device other than the HP LaserJet M1005 MFP. Repair and
replacement procedures in this chapter are for the HP LaserJet M1005 MFP and are not affected
by cosmetic differences (for example, the color of the covers) shown in these photos.
1. At the back of the device, remove two screws (callout 1).
Figure 6-19 Remove the device separation pad (1 of 2)
2. Remove the device separation pad and frame.
Figure 6-20 Remove the device separation pad (2 of 2)
ENWW Removal and replacement strategy 73