User Guide

Paper-pickup assembly
1. Remove the following assemblies.
●
Scanner assembly. See
Scanner assembly on page 67.
●
Left cover. See
Device side covers on page 82.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 86.
●
Print cartridge door. See
Print-cartridge door on page 85.
●
Front cover. See
Front cover on page 88.
●
Transfer roller. See
Transfer roller on page 80.
●
Fuser. See
Fuser on page 105.
2. Unplug and remove any additional wire-harnesses as necessary to release the paper-pickup
assembly. Unplug and remove the wire from the solenoid to the formatter.
3. Remove six screws (callout 1) and remove the assembly.
Figure 6-68 Remove the paper-pickup assembly
ENWW Removal and replacement strategy 107