User Guide

Main motor
1. Remove the following assemblies.
●
Scanner assembly. See
Scanner assembly on page 67.
●
Formatter. See
Formatter on page 94.
●
Left cover. See
Device side covers on page 82.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 86.
●
Print cartridge door. See
Print-cartridge door on page 85.
●
Front cover. See
Front cover on page 88.
●
Scanner support frame. See
Scanner support frame on page 95.
●
ECU. See
Engine controller unit on page 98.
●
Laser/scanner assembly. See
Laser/scanner assembly on page 102.
2. Disconnect the motor wire-harness connector (callout 1) and remove one screw (callout 2).
Figure 6-63 Remove the main motor (1 of 2)
ENWW Removal and replacement strategy 103