User Guide

5. Disconnect one FFC (callout 4) from the power supply.
CAUTION Do not bend or fold the FFCs during the removal or reinstallation process.
Figure 6-59 Remove the ECU (4 of 6)
6. Disconnect one FFC (callout 5) from the ECU and the wire-harness connector to the main motor
(callout 6). Remove one screw (callout 7). Release the wire-harness (callout 8) from the retainer
slot on the ECU.
Tip Unweave this wire-harness from additional wire looms to have enough slack to
disengage it from the slot on the ECU.
Figure 6-60 Remove the ECU (5 of 6)
100 Chapter 6 Removal and replacement ENWW