User Guide

3. Disconnect one FFC (callout 3) and six wire-harness connectors (callout 4) and remove them from
the wire loom.
CAUTION Do not bend or fold the FFCs during the removal or reinstallation process.
Figure 6-49 Remove the power supply (2 of 3)
4. Remove four screws (callout 5) and remove the wire-harness from the wire loom (callout 6) and
unclip the wire loom from the chassis (remove the wire-harness from this wire loom). Remove the
power supply.
Figure 6-50 Remove the power supply (3 of 3)
92 Chapter 6 Removal and replacement ENWW