User Guide

3
Chapter 2. Installation
2.1 Install the pedestal
Follow the steps illustrated below to install the pedestal for your model.
Note: The following illustrations are for reference. Your model may have a different bezel, back
cover and stand.
60.97 cm/24” Models
2.2 Connect your monitor to your computer
1. Power off and unplug your computer.
2. Connect the 15-pin ends of the signal cable to the VGA port of your monitor and the VGA OUT jack
on the back of your computer. Secure the cable by tightening the screws on both ends of the signal
cable.
3. Connect one end of the power cord to the monitor, then connect the other end of the power cords to
the nearest electrical outlet.
WARNING! To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety feature.