Setup and Install
Table Of Contents
- Introduction
- Installation
- Troubleshooting
- Glossary
- Solution summary
- Specifications
- Regulatory statements
- FCC statement
- Regulatory Model Identification Number
- Canada
- Regulatory wireless statements and required markings
- Exposure to radio frequency radiation
- Notice to users in Argentina
- Notice to users in Brazil
- Notice to users in Canada
- Notice to users in China
- European Union regulatory notice
- Notice to users in Indonesia
- Notice to users in Korea
- Notice to users in Mexico
- Notice to users in Singapore
- Notice to users in South Africa
- Notice to users in the Ukraine
- Environmental product stewardship program
- Service and support
Network computers cannot communicate with the
printer
Check the following:
●
If you previously configured the HP Jetdirect 2700w Print Server with a wireless connection to your
network, but the network computers are unable to communicate with the printer, print an
HP Jetdirect configuration page.
●
The wireless computer must be configured to match the wireless network settings on the
HP Jetdirect 2700w Print Server, including:
◦
Communication mode
◦
Network name (SSID) (case sensitive)
◦
Security type
◦
Encryption level, encryption key entries, or the specified transmit key
◦
IP address
◦
BSSID (Basic Service Set Identifier), which distinguishes one wireless LAN from another even
though they have the same SSID
●
The wireless function is turned on and operating properly (print an HP Jetdirect configuration
page).
●
The computer is within range of the HP Jetdirect 2700w Print Server.
●
If the HP Jetdirect 2700w Print Server is in peer-to-peer mode, there are fewer than six devices
total.
●
If you are initially setting up the HP Jetdirect 2700w Print Server, and the connection fails after
entering the configuration settings, reset the print server to factory-default settings (cold reset) and
try again.
ENWW
Network computers cannot communicate with the printer
9