Setup and Install
Table Of Contents
- Introduction
- Installation
- Troubleshooting
- Glossary
- Solution summary
- Specifications
- Regulatory statements
- FCC statement
- Regulatory Model Identification Number
- Canada
- Regulatory wireless statements and required markings
- Exposure to radio frequency radiation
- Notice to users in Argentina
- Notice to users in Brazil
- Notice to users in Canada
- Notice to users in China
- European Union regulatory notice
- Notice to users in Indonesia
- Notice to users in Korea
- Notice to users in Mexico
- Notice to users in Singapore
- Notice to users in South Africa
- Notice to users in the Ukraine
- Environmental product stewardship program
- Service and support
Reset to factory defaults
After you have configured the HP Jetdirect 2700w Print Server, the settings are saved in memory.
If you lose communication with the HP Jetdirect 2700w Print Server, or if it fails to operate properly,
you might need to reset the print server to its factory-default configuration. This is called a cold reset.
NOTE: Resetting the HP Jetdirect 2700w Print Server to factory-default settings will cause the print
server to lose its wireless connection to your network. Reconfiguration of wireless network settings and
reinstallation of the print server will be required.
Parameters on the HP Jetdirect 2700w Print Server can be reset to factory default values using the
following procedures.
HP LaserJet printer/MFP reset
In most cases, the HP Jetdirect 2700w Print Server is reset to factory defaults when factory settings are
reset on the printer/MFP.
CAUTION: Be sure to print an HP Jetdirect configuration page before performing a reset. Resetting
the printer clears all data from the printer memory and resets all printer settings, including network
configurations, to their factory default values. After a reset, users will be affected due to changes in
user-specified printer settings. Network systems will lose their connection to the printer.
After a reset, print an HP Jetdirect configuration page to confirm that factory-default values were
assigned. You must now re-configure the HP Jetdirect 2700w Print Server. See
Configure the print
server using the HP Embedded Web Server on page 6.
Service menu example
To perform a reset on many recent HP LaserJet printers and MFPs:
1. At the control panel, press the Home button.
2. Press the down arrow and highlight the Administration menu, then press the OK button.
3. Press the down arrow and highlight the General Settings menu, then press the OK button.
4. Press the down arrow and highlight the Restore Factory Settings option, then press the OK
button to reset the product to the original factory settings.
8 Chapter 3 Troubleshooting ENWW