Setup and Install
Table Of Contents
- Introduction
- Installation
- Troubleshooting
- Glossary
- Solution summary
- Specifications
- Regulatory statements
- FCC statement
- Regulatory Model Identification Number
- Canada
- Regulatory wireless statements and required markings
- Exposure to radio frequency radiation
- Notice to users in Argentina
- Notice to users in Brazil
- Notice to users in Canada
- Notice to users in China
- European Union regulatory notice
- Notice to users in Indonesia
- Notice to users in Korea
- Notice to users in Mexico
- Notice to users in Singapore
- Notice to users in South Africa
- Notice to users in the Ukraine
- Environmental product stewardship program
- Service and support
Verify print server operation
1. Print an HP Jetdirect configuration page to check for status messages.
The steps to print a configuration page can vary with the printer/MFP model. For most printers/
MFPs with a control panel, a menu map is provided to navigate the control panel menus. To print
a configuration page, use the menu map or see your printer/MFP documentation for specific
instructions.
2. If a message other than PRINT SERVER READY appears, try the following:
●
Verify that the printer/MFP uses the latest firmware.
●
Verify that the HP Jetdirect 2700w Print Server is firmly attached to the printer/MFP.
●
Turn off the printer/MFP, reinstall the HP Jetdirect 2700w Print Server, and turn on the
printer/MFP. Check for any displayed messages.
ENWW
Verify print server operation
5