Addendum

3
HopLimit/WSD
Set the WS-Discovery hop limit for the site local IPv6 multicast packet.
Panic Behavior
Set the printer behavior when a panic situation is encountered.
DUMP_AND_REBOOT
JUST_REBOOT
DUMP_AND_HALT
JUST_HALT
FULL_DUMP_AND_REBOOT
FULL_DUMP_AND_HALT
hw-acclrn-conf
Use hardware acceleration.
0: Disable.
1 (default): Enable.
HP Embedded Web Server
The following discusses the changes to the Networking and Web Services tabs of the HP Embedded Web
Server.
Networking tab
TCP/IP Settings
The Advanced tab now contains the CCC Logging item. By default, HP Customer Care Center logging
(CCC Logging) is enabled. To disable logging, clear the check box.
Authorization
By default, the HP Jetdirect print server contains a self-signed preinstalled certificate. When using this self-
signed certificate, the Encryption Key Length item now allows you to select an encryption key length of
2048 bits.
802.1X Authentication
Both the PEAP and EAP-TLS protocols use dynamic encryption keys for secure communication. If an
authentication failure occurs, you can set the new On Authentication Failure item to connect anyway, or
block access.
Device Announcement Agent
Use the Announcement Agent menu item to enable or disable the HP Device Announcement Agent, to set
the configuration server, and to indicate whether to require mutual authentication using certificates. When
enabled, the HP Device Announcement Agent sends an announcement to a configuration server when the
device first connects to your network. The configuration server, such as the HP Imaging and Printing Security
Center, then pushes the pre-established configuration settings to the device.