User's Manual

Store print jobs on a USB ash drive to print later
●
Introduction
●
Before you begin
●
Set up the printer for job storage
●
Create a stored job (Windows)
●
Print a stored job
●
Delete a stored job
●
Information sent to printer for Job Accounting purposes
Introduction
This section provides procedures for creating and printing documents that are stored on the USB ash drive.
These jobs can be printed at a later time.
Before you begin
The job storage feature has the following requirements:
●
A dedicated USB 2.0 ash drive with at least 16 GB free space must be installed in the rear host USB port.
This USB ash drive holds the job storage jobs sent to the printer. Removing this USB ash drive from the
printer disables the job storage feature.
●
If you are using an HP Universal Print Driver (UPD), you must use UPD version 5.9.0 or above.
Set up the printer for job storage
Complete the following processes to enable the printer job storage feature.
Step one: Install the USB ash drive
1. Locate the rear host USB port.
NOTE: On some models, the rear host USB port is covered. Remove the rear host USB port cover before
proceeding.
ENWW Store print jobs on a USB ash drive to print later 37